D-Link DVG-3016S User Manual download pdf (Page 62)

DVG-3016S/3032S User’s Manual Gateway Configuration-IVR

D-Link Systems, Inc. 59

4. Configuring the Gateway through IVR

VoIP transmits voice data (packets) via the Internet. One effect of this is that telecommunications quality is closely

related to the condition and status of the network environment. If any of the parties involved in VoIP

communications has insufficient bandwidth or frequent packet loss, the telecommunication quality will be poor.

Therefore, excellent telecommunication can only happen when the gateway is connected to the Internet and

when the network environment is stable.

Preparation

y Install the gateway according to instructions. Connect the power supply, telephone set, telephone cable,

and network cable properly as described in Chapter 2.

y If a static IP is used, confirm the correct IP settings of the WAN Port (IP address, Subnet Mask, and Default

gateway). Please contact your local Internet Service Provider (ISP) if you have any questions.

y If you are a using ADSL (PPPoE) for your network connection, confirm the account number and password.

y If you intend to operate the gateway under a NAT, the Gateway WAN Port IP Address and LAN Port should

not use the same range in order to avoid phone failures.

Basic Setup

The gateway provides two setup modes:

1. Telephone IVR Configuration Mode

2. Browser Configuration Mode

IVR configuration provides basic query and setup functions, while browser configuration provides full setup

functions.

4-1 IVR (Interactive Voice Response)

The gateway provides convenient IVR functions. Users only need to pick up a handset and enter the function

code for query and setup without using a PC.

NOTE: After finishing the setup, make sure the new settings are saved. This will enable the new

settings to take effect after the system is restarted.

Instructions

y FXO Port: to use IVR functions, dial the phone number of the FXO Port using an external line. You will hear the

instruction “enter value”, and then enter IVR password. The factory default code is “admin”. Enter

“***4144534954#” as above. You are now in IVR setting mode. (Please refer to page 45 for function codes).

y Once the first setting or query has been completed, you will hear the tone indication again. Then use the

same procedure to make a second query or setting. To exit IVR mode, simply hang up the phone.

Example: If your password is “1234”, enter “**1234#”

so that you are now in IVR setup mode. Next enter a

function code to check or configure the gateway. If your password is “admin”, enter “***4144534954#”

Please refer to the IVR Functions Table (page 45) for available functions and codes.

Example: enter “**#”

(you are now in IVR mode)Æ enter 101 (to query about the current IP address) Æ the

system responds with an IP address Æyou can continue with more settings or queries: enter 111

(to set a

new IP address) Æenter 192*168*1*2

(new IP address).

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 70 71

Comments to this Manuals

No comments

D-Link DVG-3016S User Manual Page 62

Comments to this Manuals

Related products and manuals for Telephones D-Link DVG-3016S