D-Link DES-3226L Technical Information download pdf (Page 90)

90 D-Link DES-3226L Command Line Reference

dot1x system-auth-control

This command is used to enable the dot1x authentication support on the switch. By default, the

authentication support is disabled. While disabled, the dot1x configuration is retained and can be

changed, but is not activated.

Default disabled

Format dot1x system-auth-control

Mode Global Config

no dot1x system-auth-control

This command is used to disable the dot1x authentication support on the switch.

Format no dot1x system-auth-control

Mode Global Config

dot1x timeout

This command sets the value, in seconds, of the timer used by the authenticator state machine on this

port. Depending on the token used and the value (in seconds) passed, various timeout configurable

parameters are set. The following tokens are supported.

reauth-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this

port to determine when re-authentication of the supplicant takes place. The reauth-period must be a

value in the range 1 - 65535.

quiet-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this port

to define periods of time in which it will not attempt to acquire a supplicant. The quiet-period must be a

value in the range 0 - 65535.

tx-period: Sets the value, in seconds, of the timer used by the authenticator state machine on this port to

determine when to send an EAPOL EAP Request/Identity frame to the supplicant. The quiet-period

must be a value in the range 1 - 65535.

supp-timeout: Sets the value, in seconds, of the timer used by the authenticator state machine on this

port to timeout the supplicant. The supp-timeout must be a value in the range 1 - 65535.

server-timeout: Sets the value, in seconds, of the timer used by the authenticator state machine on this

port to timeout the authentication server. The supp-timeout must be a value in the range 1 - 65535.

Default reauth-period: 3600 seconds

quiet-period: 60 seconds

tx-period: 30 seconds

supp-timeout: 30 seconds

server-timeout: 30 seconds

Format dot1x timeout {{reauth-period <seconds>} | {quiet-period <sec-

onds>} | {tx-period <seconds>} | {supp-timeout <seconds>} |

{server-timeout <seconds>}}

Mode Interface Config

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 127 128

No comments

D-Link DES-3226L Technical Information Page 90