D-Link DGS-3700 User Manual Page 44

  • Download
  • Add to my manuals
  • Print
  • Page
    / 292
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 43
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
33
Size(bytes)
Displays the size of the configuration file, in bytes.
Update time
Displays the time that the configuration file was updated to the Switch.
From
Displays the location from which the configuration file was uploaded.
User
Displays the name of the user (device) that updated this configuration file. Unknown users will be
displayed as Anonymous.
Boot Click the Boot button under this heading to use this configuration file as the boot up firmware for
the Switch. This will apply upon the next reboot of the Switch.
Active Click the Active button to enable the configuration file settings.
Delete Click the Delete button under this heading to delete this configuration file from the Switch’s
memory.
Ping Test
Ping is a small program that sends ICMP Echo packets to the IPv6 or IPv4 address you specify. The destination node
then responds to or "echoes" the packets sent from the Switch. This is very useful to verify connectivity between the
Switch and other nodes on the network.
To view this window, click Configuration > Ping Test as shown below:
Figure 2 - 38 Ping Test window
The following parameters may be configured:
Parameter Description
IPv4 Ping Test
Target IP Address
Enter the Target IPv4 Address of the host.
Repeat Pinging for
Check the Infinite times radio button, which will tell the ping program to keep sending ICMP
Echo packets to the specified IP address until the program is stopped. Or the user may opt to
Page view 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 291 292

Comments to this Manuals

No comments