D-Link DGS-3700 User Manual download pdf (Page 56)

DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual

SNMP Host Table

The SNMP Host Table window is used to set up SNMP trap recipients.

To view this window, click Configuration > SNMP Settings > SNMP Host Table as shown below:

Figure 2 - 50 SNMP Host Table window

The following parameters can set:

Parameter Description

Host IP Address

Type the IP address of the remote management station that will serve as the SNMP host

for the Switch.

User-based Security

Model

SNMPv1 – Specifies that SNMP version 1 will be used.

SNMPV2c – Specifies that SNMP version 2 will be used.

SNMPV3 – To specify that the SNMP version 3 will be used.

Security Level NoAuthNoPriv – To specify a NoAuthNoPriv security level.

AuthNoPriv – To specify an AuthNoPriv security level.

AuthPriv – To specify an AuthPriv security level.

Community String/

SNMP V3 User Name

Type in the community string or SNMP V3 user name as appropriate.

To implement your new settings, click Apply.

SNMP v6Host Table

This window is used to specify the IPv6 host IP address to which the trap packets will be sent.

To view this window, click Configuration > SNMP Settings > SNMP v6Host Table as shown below:

Figure 2 - 51 SNMP V6Host Table window

The following parameters can be configured:

Parameter Description

Host Ipv6 Address

Enter the IPv6 host IP address to which the trap packet will be sent.

User-

based Security

Model

Used the drop down menu to select the user-based security model.

SNMPv1 – Specifies that SNMP version 1 will be used. The Simple Network Management

Protocol (SNMP) version 1, is a network management protocol that provides a means to

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 291 292

No comments

D-Link DGS-3700 User Manual Page 56