D-Link DGS-3700 User Manual Page 46

  • Download
  • Add to my manuals
  • Print
  • Page
    / 292
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 45
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
35
the pull-down menus.
Loopback Mode
This function allows the user to select MAC Internal/MAC External or PHY Internal/PHY
External. MAC and PHY represent the layer on which the loopback is performed while the
Internal or External represents the local loopback mode.
State Select Enable to start internal loopback test; for external loopback, set port(s) to external
loopback mode. Select Disable to stop internal loopback test; for external loopback, recover
port(s) from external loopback mode.
Click Appy to implement changes.
VLAN Counter Settings
The VLAN Counter Settings table is used to create the control entry for VLAN traffic flow statistsics. The user can
create control entries to count statistics for specific VLANs, or to count statistics for specific ports on specific VLANs.
The statistics can be either byte count or packet count and can be counted for different frame types.
To view this window, click Configuration > VLAN Counter Settings as shown below:
Figure 2 - 40 VLAN Counter Settings window
The following parameters may be configured:
Parameter Description
VID List
Check the radius button to identify the VLAN by its VLAN ID. Enter the VID or VID list you wish
to configure.
VLAN Name
Check the radius button to identify the VLANs by their VLAN name.
Ports (e.g.:1-5)
Enter a list of ports, or check the All Ports check box to specify all the ports.
Packet Type
Use the drop down menu to select the packet type.
broadcast Specifies to count broadcast packets.
unicast Specifies to count unicast packets.
multicast Specifies to count multicast packets.
all Specifies to count all packets.
Counter Type
Use the drop down menu to select the counter type. To count at the packet level select Packet,
to count at the byte level specify Byte.
VID (1-4094)
To search for a particular VLAN, enter the VID and click Find.
Click Add to create a new entry. To remove an entry click Delete to delete all entries click Delete All.
Page view 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 291 292

Comments to this Manuals

No comments